I have a DXE relay box out at my tower to handle my Steppir feed, 6M feed
and 80/160 feed.
Each of those feeds is a type N on a 7/8" hard-line connected by a short
flexible jumper to the relay box.
The DXE box is all SO-239 so the jumpers accomplish the transition from N
to PL259 to mate.
The jumpers also act as mechanical buffers since connecting the hard-line
to the box even if the connectors were of the same type would be a
mechanical nightmare.
The connectors at the box are pretty well shielded from direct rain fall
but obviously could get water blown on to them. I'm at a very windy
location.
The connectors to the feed lines are often in need of
disconnection/reconnection as the tower is raised and lowered. This makes
the usual taping rather impractical.
The trunk back to the house is 1-5/8 hard-line with a 7-16 DIN with a
DIN-to-N adapter then a flexible jumper as the others.
What would you suggest for protecting all this stuff? A big NEMA box is a
bit impractical at this location. It would make it difficult to remove the
tower feeds when the tower needs to be lowered. The tower is an AB-621 so
mounting a NEMA on the "rocket launcher" base is out.
For now I'm just going to put a raincoat over it all: a large trash bag
with drawstrings to be replaced periodically.
I'm also considering putting a large squarish trash can inverted over it.
Suggestions welcome.
73
jim ab3cv
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|