Towertalk
[Top] [All Lists]

Re: [TowerTalk] rf choke for vertical?

To: Paul Christensen <w9ac@arrl.net>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] rf choke for vertical?
From: David Aslin G3WGN <david@aslinvc.com>
Date: Sun, 16 Dec 2018 18:32:20 +0000
List-post: <mailto:towertalk@contesting.com>
What value L Paul?
73, David G3WGN  M6O


-----Original Message-----
From: Paul Christensen [mailto:w9ac@arrl.net] 
Sent: 16 December 2018 14:28
To: towertalk@contesting.com
Subject: Re: [TowerTalk] rf choke for vertical?

You want to ensure the that the choke's self-resonant-frequency isn’t within 
80m.  I am using J.W. Miller 5252 chokes at the vertical base feed.  Purchased 
from Mouser.  

Prior to installing the Miller chokes on 80m and 160m verticals, high-voltage 
static was destroying my K3's SWR bridge Schottky diodes.  Zero problems after 
the chokes were installed.

Paul, W9AC

-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Jamie WW3S
Sent: Sunday, December 16, 2018 9:17 AM
To: towertalk@contesting.com
Subject: [TowerTalk] rf choke for vertical?

I’ve read/heard that an rf choke from the vertical to ground will help bleed 
off any static and help reduce noise levels on the vertical. For an 80m 
vertical, running 1200 watts, is the value/rating critical? 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>