Re: [TowerTalk] Ham Antenna Rotator: The Teardown

[k7lxc--- via TowerTalk <towertalk@contesting.com>]

>  Years ago I remember reading to not use grease on the ball bearings as it 
>just attracts dust and dirt. And, that the design from the factory did not 
>call for grease. Is this correct or should one use a grease on the ball 
>bearings?
    I think you're confusing the rotator ball bearings with the ball bearings 
in the Rohn thrust bearings. Grease the rotator. Do not grease the thrust 
bearing.

CheersSteve      K7LXCTOWER TECH
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk