Martin,
Thanks for the info. An easy solution !
BobK6UJ
From: Martin Sole <hs0zed@gmail.com>
To: towertalk@contesting.com
Sent: Sunday, November 18, 2018 10:01 PM
Subject: Re: [TowerTalk] C3 EL spacers ?
For a home made close coupled dipole I used clear plexiglass sheet,
about 1/4" thick. I laid strips about 1" wide and long enough to overlap
the elements then drilled holes to take a UV resistant cable tie. So far
so good and keeps everything nicely in place. I don't think the
plexiglass will last forever but my Lightning bolt quad used plexiglass
for the loop joints on the reflector element and they were quite happy
for best part of 20 years in a high UV environment.
Martin, HS0ZED
On 19/11/2018 09:29, Bob K6UJ wrote:
> I am overhauling my Force 12 C3. Two of the elements needs spacers to keep
> them from interacting in strong winds. Whats a good material to make the
> spacers out of ?
> BobK6UJ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|