Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn 25G flat, top section

To: john@kk9a.com
Subject: Re: [TowerTalk] Rohn 25G flat, top section
From: Steve Lott <lottsphoto@gmail.com>
Date: Sat, 22 Sep 2018 17:04:49 -0500
List-post: <mailto:towertalk@contesting.com>
Like John KK9A stated but here is a direct link

https://static.dxengineering.com/global/images/instructions/dxe-tb-300.pdf

I actually have this DX engineering bearing it is very well made better
design

steve
KG5VK


http://www.KG5VK.com
My Ham Radio Friends


On Sat, Sep 22, 2018 at 4:59 PM, <john@kk9a.com> wrote:

> I am not a fan of Rohn bearings, especially in corrosive environments but
> regardless I found that DX Engineering has the bolt circle pattern in their
> TB3 description.
>
> GL
> John KK9A
>
> From:   Stan Stockton <wa5rtg@gmail.com>
> Date:   Sat, 22 Sep 2018 13:46:18 -0500
>
> Need the bolt pattern for a Rohn flat, top section - current part number is
> 25AG4.or the bolt pattern for a Rohn TB3 which should fit what is drilled
> on the flat top section.  Center of hole to center of adjacent hole on the
> TB3 will work.
>
> Thanks...Stan, ZF9CW
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>