https://www.grainger.com/category/fully-threaded-studs/rods-and-studs/fasteners/ecatalog/N-13jb?okey=3%2F8-24+stainless+stud&mkey=3%2F8-24+stainless+stud&refineSearchString=3%2F8-24+stainless+stud&NLSCM=17&EndecaKeyword=3%2F8-24+stainless+stud&searchBar=true&searchRedirect=3%2F8-24+stainless+stud&sst=subset
On Sunday, August 19, 2018 7:58 PM, Andy Brinkley <nc4ab@nc4ab.com> wrote:
McMaster-Carr is my go to for odd (and even not so odd) bolts and nuts:
www.mcmaster.com
Looks like they have a 5 pack of 3/8-24 x 2" long studs made out of 18-8
stainless for $7.28
Part Number 95412A661
Andy / NC4AB
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Don
Sent: Sunday, August 19, 2018 7:03 PM
To: Towertalk <towertalk@contesting.com>
Subject: [TowerTalk] SS Double Ended Stud
Just spent a hour seaching the web for someone who might sell a 3-8-24 x 1-3/4
or 2 inch (peferred) SS double ended stud with std right hand thread (3/4 long)
which I need for an antenna project.
Anyone know of a source for a stud like this?? Or has the capacity to make one
(of course I'll pay). Cutting a thread onto SS rod I know is not easily done
with just a thread nut, vice and wrench!!!!
Don W7WLL
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|