Good lugs, tight screws on the stock terminal strip. Solder the lugs. Not too
much solder to prohibit the screw heads from seating properly on the lugs.
And your right, plugs are not the best idea. Too much possibility for water
egress.
73
Jim W7RY
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Bob K6UJ
Sent: Saturday, August 11, 2018 11:32 PM
To: Towertalk Reflector <towertalk@contesting.com>
Subject: [TowerTalk] T2X cable connection at rotor
I am replacing the old rotator cable going to a T2X on my tower. Can you
recommend a better solution for connecting the wires to the rotor other than
the stock solution ? I see the newer T2X's have an inline plug but heard that
it isn't very reliable. thanks,BobK6UJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|