Towertalk
[Top] [All Lists]

[TowerTalk] Fw: 5 Band Yagi with more than 2 elements per band

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Fw: 5 Band Yagi with more than 2 elements per band
From: Bryan Swadener via TowerTalk <towertalk@contesting.com>
Reply-to: Bryan Swadener <bswadener@yahoo.com>
Date: Mon, 30 Jul 2018 05:33:10 +0000 (UTC)
List-post: <mailto:towertalk@contesting.com>
Hi Rich,



After 40 years, I decided I was going to erect a big HF yagi, and wanted gain 
on 40m. I found a used Force12 C-4XL that has 2 linear-loaded elements (39' 
long) on 40m on one feedline. Another feedline is used with 2 full size 
elements on 20m, 2 full size elements on 15m, and 3 elements on 10m (two  of 
the latter are driven elements). VSWR bandwidth is about 100 kHz on 40m, and 
all of 20/15/10m are covered below 1.5:1. This fits on a guyed 30' boom. F12 
states it works on 17 and 12m w/ a tuner. My Kenwood TS-850SAT drives it fine 
on 17m w/ the ATU. It drives it fine on 12m w/o the ATU. Nothing was said about 
30m but, I'm able to drive it on 30m w/ the ATU. It's nice that there're no 
traps or loading coils to burn up.
The instructions describe it as a C3S + EF240. Mine came to me needing a few 
"sticks" of tubing replaced, which the seller supplied. The only thing I needed 
to buy was a coupla hundred "corrosion resistant" 1/8"x1/4" blind Pop rivets 
(McMaster-Carr).
I installed it atop my new-to-me US Tower TX-472. With the tower tilted over 
and using a 12' step ladder, I was just able to reach the mounting point but, 
nothing higher. Then, I had a eureka moment. The 2" x 30' boom on the yagi is 
five 6' sections, "splinted" together with short sections of larger tube + 1/4" 
bolts/nuts. By removing the bolts/nuts, I'm able to remove sections of boom + 
element(s), and tilt the tower nearly completely horizontal. An expensive tilt 
plate is not needed, and all antenna/tower work is performed with both feet on 
the ground. I have lots of tower + yagi photos on my Flickr page here: 
http://www.tinyurl.com/wa7prc-tower
I realize MY solution may not be what YOU need but, maybe it'll give you some 
ideas. Feel free to plagiarize & ask questions. Constructive comments are 
appreciated, too. :-)
vy 73,
Bryan WA7PRC


Date: Wed, 25 Jul 2018 07:31:13 -0500From: Richard Thorne 
<rthorne@rthorne.net>To: Towertalk <towertalk@contesting.com>Subject: 
[TowerTalk] 5 Band Yagi with more than 2 elements per band
I'm looking for a 5 band yagi (10,12,15,17 &20 meters) that has moregain than 
the 2 element per band designs.? I prefer no traps.
Steppir is not an option as I will use the antenna on two bands forso2r via a 
triplexer.
F12 used to make a 5BA, I'm not sure if JK has built one as it's notlisted on 
their website.
Suggestions?
Thanks
Rich - N5ZC


   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Fw: 5 Band Yagi with more than 2 elements per band, Bryan Swadener via TowerTalk <=