Towertalk
[Top] [All Lists]

Re: [TowerTalk] Poly rod, Fiber glass rod, Fiber Protrusion rodtension?

To: john@kk9a.com, towertalk@contesting.com
Subject: Re: [TowerTalk] Poly rod, Fiber glass rod, Fiber Protrusion rodtension?
From: kj6y--- via TowerTalk <towertalk@contesting.com>
Reply-to: kj6y@aol.com
Date: Wed, 16 May 2018 11:47:42 -0400
List-post: <mailto:towertalk@contesting.com>
I still have for sale my  the Dillon Dynanometer used for tensioning guy wires. 
 6000 lbs.


Check it out at  www.dillonforce.com
Pictures available on request.
Asking $600.00.
 
Skip Bolnick, KJ6Y
Communications Service Co
www.kj6y.com
818-522-5421
 
In a message dated 5/16/2018 4:25:42 AM Pacific Standard Time, john@kk9a.com 
writes:

 
I use a Loos gauge on 5/16 EHS. It probably reads higher than the actual

tension however you can clearly see the effect when tightening
turnbuckles. I do not believe that guy wire tension is that critical and
the Loos is easy to use and certainly better than no gauge. I see no
reason that it would not work on 3/8 EHS but this size is in the
commercial range. I use a transit to plumb the tower.

John KK9A


Jeff Blaine ac0c.com wrote:

Hard to use a Loos gauge on bigger EHS though. I've got 3/8 EHS on my
top guys and when I hold the Loos up next to it, the EHS just laughs and
calls me silly names as the nearly unbendable 3/8 EHS laughes at me...

73/jeff/ac0c
alpha-charlie-zero-charlie
www.ac0c.com

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>