Towertalk
[Top] [All Lists]

Re: [TowerTalk] Screw in anchors

To: Jeff Whisler <jwhisler33@gmail.com>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Screw in anchors
From: Tom WA9WSJ via TowerTalk <towertalk@contesting.com>
Reply-to: Tom WA9WSJ <wa9wsj@yahoo.com>
Date: Wed, 14 Mar 2018 02:11:12 +0000 (UTC)
List-post: <mailto:towertalk@contesting.com>
Hi Jeff and Andre,
I got them at a local concrete outfit. I understand that they use extra cement 
which is brought back from a construction site and they make these out of it 
instead of just dumping the extra. 
I think the ones I got weigh 3150 lbs. The other trick is getting them to your 
place. I and another guy borrowed a flatbed truck that had a crane on it, which 
was used to pick up rocks for landscaping. We could only haul two at a time due 
the ability of the truck. The guy with the backhoe moved them into place. He 
did the work while I manned the camera! :)
I paid $25.00 each. I think they make two sizes, 2 x 2 x 4 and then the ones I 
found, 2 x 2 x 6. Certainly the shorter ones would work, but they weren't 
available when i went to buy them.
73 Tom

      From: Jeff Whisler <jwhisler33@gmail.com>
 To: Tom WA9WSJ <wa9wsj@yahoo.com> 
 Sent: Tuesday, March 13, 2018 7:54 PM
 Subject: Re: [TowerTalk] Screw in anchors
   
Thank you Tom. 
 I was wondering if that was a viable option.  Where do you buy the blocks?

Sent from my iPad
On Mar 13, 2018, at 8:34 PM, Tom WA9WSJ <wa9wsj@yahoo.com> wrote:


Hello Jeff,
Along with the other helpful ideas suggested, here's how I dealt with the guy 
anchor issue.
Scroll about 1/3 the way down and find the "guying" section.. I used 
construction blocks and it was a real time saver!
BTW...You are on the right reflector for learning wise info!
GL 73 Tom
http://www.wa9wsj.com/antenna_page.htm





      From: Jeff Whisler <jwhisler33@gmail.com>
 To: Bill via TowerTalk <towertalk@contesting.com> 
 Sent: Tuesday, March 13, 2018 9:52 AM
 Subject: [TowerTalk] Screw in anchors
  
All,

I am rather new here.

I did put up 60 feet of Rohn 45 many years ago so I am not a complete
novice.

I am planning to erect a 70 ft Rohn 25G tower this summer.  The location is
very remote and heavily wooded.  The location makes using conventional cast
in-place re-enforced concrete anchors difficult and very expensive.  I
might be able to get a mini-excavator in to dig but I would certainly have
to use a pump truck to get the concrete in place.  $$$

I did have a comprehensive soil evaluation done for a conventional septic
system when I built the home in 2013.  In the area tested it perked for a
conventional system.  When they excavated for the foundation however they
found heavy clay and rocks.  Same when they drilled the well.

I am considering using AB Chance screw anchors or perhaps "Bust" anchors.
I realize that the book calls for the cast in place option but I am afraid
that will not be affordable.

Any constructive thoughts (pun intended) pro or con or other anchor ideas
would be most appreciated.

Jeff

WV9X--
J Whisler
262-623-7450
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


   


   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>