Yes, Exactly. The Rohn 25 extension was bolted to the Rohn 45 below with
large brackets upside down because the end had a bend from the storm on the
bottom leg. If I can get the two leg diameters to couple together somehow
it will be the only way to mate them. I have (3) galvanized fence couplers
that can fit over the outside perfectly over the two 25G's but I am worried
about the bead stopper in the center of them could be a breakpoint. So I
am not sure if that would work.
Herb, KV4FZ
On Mon, Feb 19, 2018 at 2:40 AM, Grant Saviers <grants2@pacbell.net> wrote:
> Am I correct that the two ends are the leg diameters not the swaged
> diameters? If so, a simple anything steel solid rod turned to the leg id
> of 1.125" minus 0.005" clearance (1.120") and drilled for the bolts will
> join the sections.
>
> Grant KZ1W
>
>
> On 2/18/2018 11:22 AM, Herbert Schoenbohm wrote:
>
>> Amazing but my tower erector put the last section of Rohn 25G with the
>> gender wrong and coupled with a special adapter to Rohn 45 below. Now I
>> am trying to put up a Rohn 25G top section but the genders are the same
>> size. Duh. It would a major project to flip the wrong gender Rohn 25G
>> around. So I am wondering if a set of (3) coupling sleeves are available
>> anywhere. I check both the Amerite and the Rohn catalog but came up
>> empty.
>> These sleeves would be the same size as the diameter of a base plate.
>> But welding two base plates or bolting them together is a way out but
>> expensive. Any suggestions would be appreciated.
>>
>> Herb Schoenbohm, KV4FZ
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|