The hole is probably a bit bigger than what you wanted to dig unless you
were a much better operator than most.
Yes you should be worried. You could shore up the sides with plywood
and posts but that would be a lot of work for nothing.
W0MU
On 2/10/2018 7:51 AM, jimlux wrote:
On 2/10/18 6:33 AM, Richard Solomon wrote:
Better yet, just fill the hole with
concrete. It's cheaper than a
funeral.
Square up the part showing above
ground, no one will see whats
below it.
Really.. Dick has got the right idea here.. if the corner is a bit
rounded at the bottom, it's not like the cube o'concrete will fail to
be a "big lump o' mass".
Use your mini excavator to dig a few inches deeper in the middle if
you're worried about having leftover concrete from the truck.
On 2/10/2018 7:52 AM, jimlux wrote:
On 2/9/18 11:04 AM, Joe Partlow wrote:
So I'm in the process of digging the hole for my tower foundation.
I've
dug
most of it out with a mini-excavator but now I have to climb down
inside
to
finish up the corners and such. the hole will be 4' X 4' x 6' deep.
Should
I be worried about cave-ins?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|