I was able to purchase new a 475' roll of CommScope 1/2" HELIAX Superflexible
Smoothwall Aluminum coax for my HF station for a very good price. I have about
a 150' run from a two element 5 band quad up at 60'. And BTW, the
"Superflexible cable" is not that flexible! But the specs are very good for HF.
I have tried to find a way to attach the Type N connectors to the cable without
the use of the expensive tools used typically by professional installers. I
purchased pair of JMA 500 connectors but after watching their video they used
some expensive tools and guns. I could splurge for a Prep tool but the
HCG-Frameset compression gun is pricey. Nice and quick to be sure but thousands
of dollars for tools I will use once very 10 years or so is steep.
Is there a DIY guide to install type N connectors on 1/2" smoothwall? Do I need
the compression tool or can it be done without one some other way? Has anyone
made a DIY compression tool?
Rick Wheeler
K4LX
Rick Wheeler
[http://www.omalley.com/uploads/2/4/4/1/24411441/5669729.png]
www.omalley.com
<http://www.omalley.com/>O'Malley Manufacturing, Inc.
4228 8th Avenue South / Saint Petersburg, FL 33711
info@omalley.com<mailto:info@omalley.com>
Office: (727) 327-6817
Toll Free: (800) 593-0004
Fax: (727) 323-2771
IMPORTANT NOTICE: This e-mail message is intended to be received only by
persons entitled to receive the confidential information it may contain. E-mail
messages to clients of O'Malley Manufacturing, Inc. may contain information
that is confidential and legally privileged. Please do not read, copy, forward,
or store this message unless you are an intended recipient of it. If you have
received this message in error, please forward it to the sender and delete it
completely from your computer system.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|