Hi Mike,
I bought all of my tools, and continue to buy all of my connectors, from
Davis RF: http://www.davisrf.com/index.php
73 -- Larry -- W1DYJ
-----Original Message-----
From: Bryan Fields
Sent: Monday, December 04, 2017 6:12
To: 'towertalk reflector'
Subject: Re: [TowerTalk] Connector Crimping Tool Advice
On 12/3/17 11:59 PM, Mike Ryan wrote:
I am SURE that this has been discussed before, however I now need to pay
more attention to some first hand accounts and advise on the subject.
If only there was some way to search for things like this, however I'm aware
of no such technology. I suspect if such a technology was developed, it
would
become an overnight success and make its inventor untold wealth.
I am
considering the purchase of connectors and the proper tool for crimping
these connectors onto LMR-400 primarily and some other cables over time.
I
have no problem installing the 'old fashioned' style connectors but hear
more reports of crimp style connectors being used on the LMR-400 cable
than
in the past.
Buy the proper tools:
https://www.tessco.com/products/displayProductInfo.do?sku=416133
or the cheaper kits, which are almost as good:
https://www.tessco.com/products/displayProductInfo.do?sku=33713
Stripper and deburr tool:
https://www.tessco.com/products/displayProductInfo.do?sku=315538
N connectors, use the EZ series.
https://www.tessco.com/products/displayProductInfo.do?sku=338985
PL259's (almost double the N price!)
https://www.tessco.com/products/displayProductInfo.do?sku=419089
--
Bryan Fields
727-409-1194 - Voice
http://bryanfields.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|