Ted,
I have a 2 el Cushcraft 40 I took down and the driven element is the same as
the D40. It is true the joints do cause problems at times but that should cause
the D40 not to have resonance at all. I suspect either the lengths are wrong
so check them out as you should all be CW, mid band , or SSB on all settings.
If that checks out look at the capacity hats. If one is loose this can cause
the problem. If that checks out is there an antenna nearby? I tested my driven
element and at first it was nearly 2 to 1 at 7150 when before it was 1.3. I
moved the reflector away as the tip was only 3 feet away. Then the SWR was
just below 1.4 but at 12 feet that seemed to be OK. Hope you find it OK.
73 Dave K4JRB
On 11/24/2017 9:45 PM, Ted Boerkamp wrote:
Hello all.....I had my D40 reinstalled on my tower a month ago and all was
good...swr curve right where it should be...
7.080 swr 1:1.....now today I turn on the radio and it is all out of
wack.....swr so high it trips the radio....
I tuned around the radio a bit and notice the resonance point is now at 7.44
at swr 1.3:1
I went out to check and the entire antenna is still on the tower. Nothing
missing.
Could one of the two feed wires be open to either side of the dipole??
What would cause this??? My other antennas on the tower appear to be
fine....they are all fed from one coax
thru an ameritron RCS4 switch box. Any suggestions or words of wisdom are
welcome.
Thanks
Ted VE3SS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk