I had a homebrew aluminum mast about 25' long with a small tribander on top
and I walked that up in VP2V, PJ7, ZF2, etc without too much effort. 45'
might be difficult but possible with a hinged base and maybe a falling
derrick. Home brewing a vertically telescoping pipe tower is a lot of work
and expense and it is probably cheaper just to replace your bent Rohn
sections. I assume that the base and anchors are still good.
John KK9A
To: towertalk@contesting.com
Subject: [TowerTalk] Recommendations
From: Alfredo via TowerTalk <towertalk@contesting.com>
Reply-to: Alfredo <wp3c@aol.com>
Date: Wed, 22 Nov 2017 17:14:40 -0600
Hi
I need recommendations
I want to order to make a 45-50 feet Telescopic mástil for a light antenna.
I
want to install a pulling hand winch. I was thinking in a galvanized rounded
tube of 20 feet of 4, 3 and 2 inches. One inside of the other. The square
one
is better but the cost is too much in PR. Any recommendation, manual,
webpage
or something else?
Any recommendation will be well appreciated. Thanks 73"
Alfredo Velez WP3C/NP4DX
e-mail: mailto:wp3c@aol.com
Web: http://wp3c73.wixsite.com/wp3c
Sent from my T-Mobile 4G LTE Device
_________________________________________
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|