Hmmm – I might have to try (something like) that Kim.
I did put on a little bit of black e-tape (like tiny flags) here and there on
some of the more or less “paths” in the woods, so I (or deer coming through)
would
see it and to keep it low key so I couldn’t see it from the house, but I am now
thinking about using something like that in the future.
I have some green marker tape that would be “relatively” camo (at least until
it fades from UV somewhat) so that might also be an option.
Since this tiny sliver of woods is not particularly thick I’d rather not look
out over 28 raised radials every day. I am sure the neighbours
appreciate the fact the wires and end of radial supports are for all intents
and purpose ‘invisible’, too ;-D
I’ve rec’d a few questions directly why I didn’t mount the bases of (some) of
the verticals higher. Here’s my reply to that:
Because all my 4-squares are pretty much on a steep slope in a small
rectangular strip of woods, adjacent my yard, some are aprox 7-8’ AGL at the
base of the vertical (and not as prone to deer damage as the radials are really
high, at least where they start out), but the ones located closer to the lawn,
on the edge of the woods, are only a couple feet above the ground level and do
employ gullwing radials already.
If I had made the lower ones, say, 7-8’, the ones deep in the woods would’ve
needed to be 10-15’ high and not reachable without a ladder (not really
possible over the very rocky ground, down in the woods)
I designed it this way to make them all electrically/physically in the same
plane, regardless of the undulating nature of the Earth underneath the verts.
It’s not perfect.
Deer are a menace.
They are lovely to look at, but eat my wifes plants too.
If I was good with a bow and arrow (or even throwing a big rock), I wager I
could get 3 a week………until I finished them all off ;-)
AA
Mike, Coreen & Corey
Keswick Ridge, NB
From: Kim Elmore [mailto:cw_de_n5op@sbcglobal.net]
Sent: November 11, 2017 3:55 PM
To: Mike Smith VE9AA
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] Deer are a PITA but Trees are great - REMEMBER
You might try tying strips of white cloth at intervals along the radials. That
way, the deer can at least see them.
73,
Kim N5OP
"People that make music together cannot be enemies, at least as long as the
music lasts." -- Paul Hindemith
On Nov 11, 2017, at 11:57, Mike Smith VE9AA <ve9aa@nbnet.nb.ca> wrote:
I just spent the last 2 hours out in the woods during antenna season (ie:
blustery wind, subzero cold, ice to slip on but no leaves on the trees)
What was I doing you say? … Repairing 26 out of my 28 raised radials on all
my wire 4-sq arrays in prep for contest season. Only one wire itself was
broken (I use fencing wire) but all the ends that attach to supports were
broken.
I accept Mother Natures wrath with some of my radials being broken due to
swaying trees and falling widow-makers and don’t give it a second thought…
It’s almost a ritual just to do the yearly repairs. HOWEVER the friggin’
deer here are relentless ! It’s no exaggeration to say we generally go no
more than 1 or 2 days w/o seeing deer either in the back 40 or crossing the
road near our house. Two have been hit within 100’ of my driveway this fall
alone.
I found radials up and over trees, going in the wrong directions, down under
big rocks and one was wrapped around a tree twice!.....at one point when I
got to the end of a particular 80m radial I thought for sure I’d find a dead
deer at the end – LOL….but he must have finally got away….or maybe the
cougar that was reported here 2 months ago got him.
Last year when I installed all these 4-squares I got the (not so) bright
idea I would use that oiled hemp string to go between the ends of the
radials and the nearest tree. Well…..it was true….hemp is aesthetically
pleasing (can’t see it from the house_) but definitely not deer proof.
There was a radial here and there, which even had old limbs of trees on them
where the hemp was NOT broken, so I can only imagine the deer chew on the
stuff or something – HI !
I have 2 repairs still left to do (the most difficult) where the (wire)
verticals themselves came down.(Mother Nature, not deer) One of the 160m
ones is always tough to get up over a couple trees and I don’t look forward
to the task. For now, I have repaired all the radials with more hemp, but
am contemplating doubling them up with 40lb test fishing line. I don’t
really want to go to ¼” nylon as I could see it from the house and road.
I really don’t want to raise them up from the 4-5’ they are all at now to
something higher as I’ll have to reengineering all the coax phasing lines
and the locations of the bases of all the verticals, re-tweak all the SWR’s
etc.
I guess I just like to complain ;-)………
It could be worse….I COULD be living in downtown Vancouver or NYC or London
with no land and no trees.
Thank God for New Brunswick, Canada and our wonderful trees !
At this time of year, besides fallen wires and trees, we should also
remember the fallen in the World Wars so that we all can enjoy the life we
lead today.
For now I’ve put on a fresh warm hoodie, (Ironic that it says “Newfoundland
& Labrador”, not “New Brunswick”), brewed a cup of Tim Hortons coffee and am
thankful for what I do have.
Mike VE9 Arborist Arborist !
p.s.-can’t/won’t do ground radials….steep incline in the woods on the side
of an old farm field, so it’s rocky, covered in leaves and the deer hooves
would get caught up in them anyways.
Mike, Coreen & Corey
Keswick Ridge, NB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting..com/mailman/listinfo/towertalk
<http://lists.contesting.com/mailman/listinfo/towertalk>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|