I would love to see photos of this full sized 80m beam. I wonder if the
element spacing could be designed to cover the whole band without switching
in inductors. So, after you design this beast and install a commercial
tower for it, you still need a rotator. I do not think even Kurt's large
P.P. is up to that task.
John KK9A
To: <towertalk@contesting.com>
Subject: [TowerTalk] Some Unique Heavy Lifting....
From: "Jim Thomson" <jim.thom@telus.net>
Date: Tue, 7 Nov 2017 10:40:03 -0800
## hats off to you Kurt ! I just spent the last couple of hours running
numbers through YM.... for a full sized 80m REF. What a bitch of a job.
I
took my
40M full sized REF design, that started at 2.25 inch OD x .240 wall...and
tapered down to .375 tips.... and simply started adding bigger and bigger OD
sections inboard.
I was up to 4.5 inch OD x .316 wall to get anywhere decent for
windload...with no ice load. Then started playing with single and multiple
overhead truss lines, trussing each half of the REF, in
1-2-3 locations. Even then, the overhead truss lines dont do anything for
horz deflection, so started adding more truss lines in the horz plane, to
minimize horz deflection.
It all sorta works in the end, but I wonder if at that point, Im designing
a
80M REF.... or a biplane or triplane, with truss lines galore ! It was
more
of a fun exercise to get a feel for what is involved.
The weight of the 80M REF alone ends up beyond crazy, like 360 lbs, not
including any hardware or truss lines.
Aluminum tower sections, for the in board ends, just might be a better
bet.
But I have zero experience with Aluminum tower sections used as eles.
## IMO, this is one place where loaded 80M elements would be a godsend.
Something more reasonable in length, like say 90-94 ft max, with 28-32 ft
long
T bars..aka capacity hats, and
a seco systems tornado drive at the feedpoint, would greatly reduce the
weight... vs the 146 foot long REF on the full sized 80m behemoth. With a
tornado drive at the center of each element,
then the entire array could be tuned for max FB and flat swr across the
entire band from 3500-4000. Any helical hairpin would be a trick, not an
issue if a 3 el used, and the DE could be gotten
to at the top of any tower. On a 2el, perhaps either a much smaller
compressible coil assy could be used, or vac relays employed to change taps
on
the hairpin.
## The weight piles up... fast on these large arrays. Then you have to
get
it up there, keep it up there..and also rotate it.
Again, kudos to anybody who tackles these massive projects.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|