Here is a description of the connectors I am using:
https://www.rfparts.com/connectors-heliax/connectors-78heliax/78helicon-ldf/716f78r.html
Keith
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf
Of Clay Autery
Sent: Tuesday, October 17, 2017 9:33 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] More information about my problem; . Re:
Heliax acting strangely: Help?
I'm digging that setup where you inject the waterproofing into the
back half of the connector....
Those are 7/17 DIN connectors?
______________________
Clay Autery, KY5G
MONTAC Enterprises
(318) 518-1389
On 10/17/2017 8:14 AM, Keith Dutson wrote:
Peter,
Nice. I do not see use of these on any installation in the
Houston/Gulf Coast area. Maybe we are just cheap. 😊
The video feed was really slow. I went to bed, and replayed after
it was fully downloaded. Good job on the connector replacement.
That connector is quite different from the ones I have. I would
likely drop something while on the tower, so would need lots of spares.
73, Keith NM5G
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
Peter
Sent: Monday, October 16, 2017 12:11 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] More information about my problem; . Re:
Heliax acting strangely: Help?
Keith,
Did you look at
https://www.alibaba.com/product-detail/1-2-Cable-DIN-7-16_60222039246.html
?
We at PI4CC used them.
A video where I repace a bad connector up the tower is at
https://www.pi4cc.nl/album/20M%20connector/coax%20plug%2020M.mp4
At 3 minutes you see this enclouse
Peter
PC2A
https://www.pi4cc.nl
Op 16-10-2017 om 15:55 schreef Keith Dutson:
I have a 170' length of LDF5-50A (donated) to put up soon for my 2
meter repeater. I purchased NOS Andrew LDF5-50A DIN connectors at a
Hamfest for
$20 each. These will be connected at each end to Andrew NOS
F4A-PNMDM
-22-NX1 22' SureFlex jumpers (DIN to N male) acquired at Dayton for
another
$20 each.
Although this cable is all commercial, it still needs to be
waterproofed. I plan to use Scotch 88 and 2228 (88 sticky side
out-2228-88 sticky side in) for waterproofing. This has proven to be
waterproof on my other repeater at
500 feet. The antenna there is subject to severe weather and must be
replaced every two years, so I need to open the connection without
damaging the connectors.
Keith NM5G
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk