One of the favorites (although I don't know by what percent) was
wrapping the first layer with the sticky side out. It does leave the
connectors nice and clean. OTOH there was a complaint about the hot melt
glue from flooded heat shrink not adhering. IOW, to diametrically
opposed approaches.
The answer for the hot melt glue not adhering is simple foreign
material. A fingerprint, lube used to flood connectors, or just plain
skin oil/sweat will prevent hot melt glue, or tape from forming a good
mechanical connection. This is a place where cleanliness is important.
For good adhesion whether tape or hot melt glue, the connectors and coax
must be clean. The tape and/or the hot melt glue must adhere with no voids
One thing with either hot melt glue, or tape. If it has food adhesion to
both the metal and the coax they both add strength. "Typically" as most
hams install UHF connectors they are relatively weak. When the hot
shrink tube is installed over the connectors and out onto the coax
jacket of most RG8 type coax, the connection will support my 170# plus
gear. IOW, about 200#. I've had taped connections fail that test. When
the inner layer is wound sticky side out the only additional strength
has to come from the exterior wrap that extends onto the coax jacket on
both sides
One additional comment about flooded coax connectors. Forget trying to
clean and solder. Just use crimp connectors.
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|