[TowerTalk] Installing a Ham-IV rotor on Tashjian w-51 tower

[Bob Richards <rwrcon@mindspring.com>]

I have my new Tashjian W-51 tower installed and working but have found 
that I can only install my Ham-IV rotor by disassembling the rotor and 
reassembling it inside the tower section.  I want to install the rotor 
about 7 feet from the top of the top section. The rotor will fit but 
I've not been successful getting it back together without losing some of 
the bearings.
Also the rotor plate is just a press fit inside the tower section.  No 
bolts or clamps.  Is it supposed to be permanently welded in?
Any advice or experience would be appreciated.   Bob NZ6G

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk