Electric code requires conduit assembly prior to running wire/cable for a
reason.
On Mon, Aug 28, 2017 at 1:29 PM William Carr <k5tu@att.net> wrote:
> I used this exact procedure and it worked well. I had 4 runs of
> LMR-400-DB and one of 1/2 inch heliax in 4" conduit.
> Kim K5TU
>
> Sent from Yahoo Mail on Android
>
> On Mon, Aug 28, 2017 at 14:36, K7LXC--- via TowerTalk<
> towertalk@contesting.com> wrote: > How about laying out the cables in
> a bundle and then slipping each ten
> foot abs piece over the end of the cables and slide it up to the
> previous
> abs piece and glue them together one at a time. In that manner I would
> not have to Pull heavy cable. I would have to watch the abs glue as it
> may
> melt the cable coverings.
>
> Yes, you would. Had a customer who did that very thing that resulted
> in that particular run of cable was there permanently with no chance of
> swapping it out.
>
> Be careful. Be VERY careful!
>
> Cheers,
> Steve K7LXC
> TOWER TECH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|