Well -- here we go again. Way to paint fiberglas pole is to purchase a
cheeeeep pvc pipe of adequate size, along with one end plugged -- put paint
in, dip pole/spreader .. pull out, drip dry, pour left over paint back in
container -- worky worky! 73 Mark AA6DX
-----Original Message-----
From: Clay Autery
Sent: Monday, July 31, 2017 7:58 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Fiberglass life expectancy
I'd rather poke my eyes out than use a roller... I invested in a NICE
HVLP gun (body shop quality) a long time ago and built an air dryer
system to hook to the compressor for all the tools and an extra module
that additionally dries the paint gun air supply.
And I have a tote with all the paint tarps to rig up a small paint
booth. Use some A/C fans I scrounged for exhaust venting...
IF I couldn't use a spray gun, I'd rather use disposable cotton gloves
over surgical gloves and put the paint on LITERALLY by hand... We used
to do this in the oilfield... WAYYYYYYYYYYYY faster than a roller.
73,
______________________
Clay Autery, KY5G
MONTAC Enterprises
(318) 518-1389
On 7/31/2017 9:34 PM, Roger (K8RI) on TT wrote:
HVLP spraying is fairly efficient, but there is a learning curve and
the initial portion of the curve can be high waste. Depending on the
equipment, cleanup can be a royal PITA. Inexpensive equipment may
have plastic parts that are vulnerable to paint thinners as benign as
Mineral Spirits) even though most paint requires little thinner when
used in HVLP guns.
Personally I don't like the results with rollers on tubes and much
prefer the HVLP, EXCEPT being inherently lazy, I really dislike the
cleanup.
73, Roger (K8RI)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|