I see you are located in Sun City West, Arizona. Thereis a machine shop
community club there in Sun City. Last time I looked into it, the club
was populated by some very capable machinistsalong with modern machine
shopequipment. Sounds like a fun machine shop project...
Stephen Lee, N7RV
On 7/27/2017 9:53 PM, Scotty wrote:
US Tower model TX-455 MDP (motorized with positive pull-down) uses a 4 groove
pulley with the number 3V315SH stamped on it. The bearing is broken. What do
you suggest? Is the complete part available? Can I take it to some shop and
get a new bearing put in?
Scotty W7SW
W7SW@ARRL.NET
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|