Towertalk
[Top] [All Lists]

[TowerTalk] Galling and seizing of SS nuts to SS threaded

To: <towertalk@contesting.com>, "Ian White" <gm3sek@ifwtech.co.uk>
Subject: [TowerTalk] Galling and seizing of SS nuts to SS threaded
From: "Jim Thomson" <jim.thom@telus.net>
Date: Wed, 5 Jul 2017 09:30:25 -0700
List-post: <mailto:towertalk@contesting.com>
Date: Mon, 3 Jul 2017 22:22:39 +0100
From: "Ian White" <gm3sek@ifwtech.co.uk>
To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Galling and seizing of SS nuts to SS threaded
studs and bolts.

<I use Blue Loctite 2400 which comes in a simple no-mess squeeze bottle.

<Apply 2-3 drops on the bolt thread at the location where the nut will be 
tightened, and while still liquid the Loctite will act as a lubricant to 
prevent galling. 

<10-20 minutes later it has set solid, positively locking the nut and also 
sealing the thread gap against corrosion. 

<The Blue Loctite grades like 2400 are specifically designed to be loosed using 
hand tools, and can be applied again to the same hardware.

<One product does the whole job - no mess, no trouble.

<73 from Ian GM3SEK

##  I have never tried Blue loctite on SS hard ware.   Are you also using   SS 
nylocks with the SS bolts + SS screws...or just  SS regular nuts ??? 
Can u even use loctite with SS nylock nuts  ?  
What else that might work is purple loctite.  I have never used it, but 
apparently its slightly weaker than the blue stuff..and may well be ideal for a 
lot of various applications.  
What I would not recommend is red loctite.  Red loctite  is as good as 
welded....esp with SS machine screws...  you cant get em out.  

Jim   VE7RF 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>