Towertalk
[Top] [All Lists]

[TowerTalk] Subject: Re: Yaesu mast clamps

To: towertalk@xxxxxxxxxxxxxx
Subject: [TowerTalk] Subject: Re: Yaesu mast clamps
From: Jon Zaimes <jz73@xxxxxxxxxxx>
Date: Fri, 2 Jun 2017 10:32:14 -0400
List-post: <mailto:towertalk@contesting.com>
Roger,


There also is a specific order in which to tighten the individual bolts. These 
instructions are on a separate sheet that comes with new Yaesu rotors but for 
some reason the info wasn't in the manual. These instructions also specify the 
bolts should be tightened only until the lock washers are flattened, not 
tighter. If tightened beyond this, the clamps will break. These can't be 
treated like Tailtwisters etc. when tightening.






73/Jon


Jon P. Zaimes, AA1K
Tower climber for hire
http://www.aa1k.us/
Cell: 302-632-2353
email: jz73@xxxxxxxxxxx or aa1k@xxxxxxxx





----------------------------------------------------------------------------------------
Re: [TowerTalk] Yaesu mast clamps
from [john@xxxxxxxx]    [Permanent Link][Original]
To:     towertalk@xxxxxxxxxxxxxx
Subject:        Re: [TowerTalk] Yaesu mast clamps
From:   "john@xxxxxxxx" <john@xxxxxxxx>
Date:   Fri, 19 May 2017 08:34:38 -0400
List-post:      <towertalk@xxxxxxxxxxxxxx">mailto:towertalk@xxxxxxxxxxxxxx>
I had two towers in Aruba both had Yaesu rotators, you can see a photo
here -> http://www.p40a.com . I installed them exactly per the
manufacture's instructions. Anyone that has been to Aruba knows that the
wind almost never stops. My monobanders rocked back and forth along 24
hours a day. The Yaesu clamps never slipped, nothing elongated and the
rotators never failed to turn the antennas.  I have also used a smaller
G-800 for temporary expedition antenna and again no issues.


John KK9A




To:     towertalk@xxxxxxxxxxxxxx
Subject:        Re: [TowerTalk] Yaesu mast clamps
From:   Roger D Johnson <n1rj@xxxxxxxxxxxxxx>
Date:   Fri, 19 May 2017 07:24:59 -0400


Yours maybe...mine not so well. The cast clamps will break if you try to
tighten
them securely. Yaesu finally put holes in the clamps for a through bolt but I
don't
want to do that. The constant movement of the antenna will elongate the holes
in the Al in short order. A very poor design!


73, Roger




On 5/18/2017 9:21 PM, john@xxxxxxxx wrote:
A solution to what?  They are adjustable for various size masts and they
grip it well.


John KK9A


_______________________________________________










_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Subject: Re: Yaesu mast clamps, Jon Zaimes <=