If you can get a hacksaw blade and a single style handle, insert and saw
through the inside (not too deep) then break it out a piece at a time. It is
slow and tedious, but I have done it.
Dave, K4TO
> On May 8, 2017, at 8:35 PM, Stein-Roar Brobakken <post@lb3re.com> wrote:
>
> Hi
>
> Try to boil some hot water, fill into a big cup with a teaspon baking soda,
> fill this into the tube parts.
>
>
> Best Regards,
> Stein-Roar Brobakken
> LB3RE K3RAG
> www.lb3re.com
> post@lb3re.com
>
>
>> Den 9. mai 2017 kl. 02.21 skrev Dave Thompson <thompson@mindspring.com>:
>>
>> I got a big box of material from MFJ/Cushcraft and some hardware is missing
>> but I can get that locally but the driven element for my old 402-CD (old
>> version) broke off about 3 inches from the center insulator. The insulator
>> is formed for the 1.25" aluminum to fit inside. The broken piece is stuck
>> and won't budge. Any ideas on how to get it out so I can install the new
>> aluminum?
>>
>> Don't know if MFJ/Cushcraft still has the insulator so I may be looking for
>> a broken 402-CD that had a good insulator.
>>
>> 73 Dave K4JRB
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|