I've never seen a "T base drawing" (except what hams have done as a
sketch by measuring one). As you note, they say this is proprietary, as
are the tower section detail drawings. The tower specs show the
foundation design and the base bolt pattern if that is what you need.
These are on the UST web site, eg
http://www.ustower.com/wp-content/uploads/2014/05/TMM-433HD.pdf
I just went around with Rohn re the mechanical properties for sections,
and now they won't part with this either. How does a structural
engineer get the data to do calcs?? I need 45, 55 and 65 numbers.
"We've been copied" was the excuse, but that seems pretty ridiculous
since there are no design details in that data. Any copies lurking out
there? I have the 25 section data if a copy is needed.
Grant KZ1W
On 5/8/2017 9:58 AM, Joe Partlow wrote:
Does anyone have the drawing for the T-Base used on the US Tower TMM433HD,
TMM541SS, HDX555 & TX472? UST does not seem to want to part with a copy.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|