I recently had some tower work done. Ihave a Rohn 25 tower up 60 FT. I have
a C-3 and a 6-element Cushcraft 6Mon it. Both antennas were doing fine – SWR
essentially flat on the C-3and around 1.5:1 on the 6M. They were both mounted
on a 9 FT mast,separated by about 6 FT. The job was to replace the 9 FT mast
witha 15 FT lighter mast and to install a new 12/17M WARC Cushcraft antenna.
The new setup had the 12/17M antenna atthe top of the mast; the 6M in the
middle, phased at 90 degrees to the otherbeams - – separated by roughly 6 FT
between it and the lower C-3 and the WARC. After the install, I am noticing a
2.0:1. 2.4:1 SWR on the C-3 on 20M only; 15M & 10M are OK. On the 6M –3.0+
SWR. Do I have an interaction problem betweenthe 6M and C-3? Should the 6M be
at the top of themast? Offset to the others, or not? Jeff/ K1ZN
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|