And how can you not tie the tower ground to the entry panel? The coax
shield(s) are tied to the tower at top and bottom. They are then tied to
the CPG at the entry panel. I have 3 LMR-600 plus 2 BuryFkex cables from
the tower to the entry panel ans polyphasers.
It's true that you don't need an "extra" ground cable, but were mine
farther from the house as in the case of the LM470 which ties into the
overall ground system there are still lots of #2 ground cables tied
together.
73, Roger (K8RKI)
On 1/31/2017 4:52 PM, Jim Brown wrote:
On Tue,1/31/2017 11:17 AM, Larry Gadallah wrote:
Does anyone have any references to good examples or best practices for
setting up a flexible, maintainable system for cable entry into
(residential) buildings at or close to ground level?
I think this is pretty good. N0AX has used much of it for a book he's
just finishing for ARRL on the topic.
http://k9yc.com/GroundingAndAudio.pdf
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|