Towertalk
[Top] [All Lists]

Re: [TowerTalk] Force 12

To: Jim Thomson <jim.thom@telus.net>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Force 12
From: Wayne Kline <w3ea@hotmail.com>
Date: Thu, 19 Jan 2017 21:35:11 +0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
IMHO I think the original F-12 Boom to Mast pate design was an issue in all 
except the smaller C-3

well documented  issue .

But as far as  performance.... there performance was  above par to manufactured 
antennas at there tenure.


Wayne W3EA



________________________________
From: TowerTalk <towertalk-bounces@contesting.com> on behalf of Jim Thomson 
<jim.thom@telus.net>
Sent: Thursday, January 19, 2017 11:44 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Force 12

Date: Thu, 19 Jan 2017 15:37:14 +0000
From: william radice <k4owr@outlook.com>
To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Force 12

:::: people finally realized that Force 12 antennas, while nicely built, simply 
don't outperform other antennas costing half the price. I've had a lot of them 
and they all performed poorly.

BILL K4OWR

##    Which f12 antennas did you have that did not perform ?

##   One item that F12 exceled at was their infamous Boom  to mast pair of 
plates.  I ran with their concept, and beefed it up some with several HB 
versions of it.    I used .375 inch thick
6061-T6  for both the vert + Horz  plate.   Then used the Dx eng super jumbo 
mast clamps  for the vert plate to mast.... and Dx eng  SS .375 inch  U bolts 
and  solid al saddles for the
Horz plate to boom.  Bomb proof.   The beauty of this F12 design is.... the 
boom can tilt a huge amount.

##  Every other  boom to mast scheme I have seen both present and past is 
cumbersome and time consuming.   The latest version that f12 used to mount 
their eles to the boom is  extremely robust.
It uses  .25 inch thick   wrap around  plates, instead of the older f12  multi 
right angle version.  New  f12 version uses  20 x .25 inch rivets on all 4 x 
sides.

Jim  VE7RF

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

TowerTalk Info Page - 
Contesting<http://lists.contesting.com/mailman/listinfo/towertalk>
lists.contesting.com
TowerTalk is for discussion of tower and HF antenna construction topics. TT 
members have lots of helpful information and are happy to share it.



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>