I too have a SMA string inverter. NO HF RFI. If I place a two meter HT
about 3-5 feet from the inverter I get hash on some freqs. Otherwise no
problems at all. I have a 3KW system that over the course of a year
produces more energy than I consume. No Air Conditioning here, but I have
two freezers and two refrigerators. LP stove and HW heater.
One of the best and most rewarding projects I have ever done. A photo of
the self-installed system is on my QRZ page.
Don't believe installers who tell you they shed snow! Even with my array
tilted at approx. 40 degs, I need to sweep wet snow off with a broom on a
telescopic painters pole. I can access the garage roof mounted panels from
the ground using a step ladder. Sure, eventually the snow will
melt.........
Good luck with your project!
73,
Karl
WD9BGA
-----Original Message-----
From: Howard Hoyt
Sent: Thursday, January 19, 2017 10:44 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Solar Panel RFI/Microinverters
Hi all,
When I was researching for my 6 KW system in 2011, I used a small
portable Eton emergency radio tuned to static above the AM BCB to listen
for RFI when visiting sites. There was a large difference between
manufacturers, and I did hear some RFI from the (at the time) new
Enphase microinverters, so I discounted using them, perhaps they are
different now. I know the exact wire routing and grounding can make a
large difference in both conducted and radiated RFI, so I also thought
if RFI should it occur, it would be easier to address just one or two
sources as opposed to 20 (the number of microinverters I'd need).
Among the large string inverters I originally wanted to purchase
Schneider, but the RFI was quite a bit higher than the quietest brand I
found, SMA. I ended up purchasing two German manufactured SMA SunnyBoy
4000 units and split my PV string in half. The system is monitored
using a SMA WebBox and I can see the data in real-time online. When I
did the install I made all above-ground AC and DC wiring in steel EMT,
and twisted the current carrying pairs before pulling. I did not choke
any DC input lines or AC outputs, and using a Tek 2712 SA on my 235'
dipole which is 130' away from the PV array I cannot see any hash or
noise floor increase when the system is on or off from 1.8 MHz up.
Below that BCB signals swamp everything.
Given the large number of variables between each PV install I can only
state that in my particular situation using SMA inverters and twisted
pair wiring in steel conduit there is an acceptably low level of
conducted and radiated RFI. There are much cheaper inverters available,
but the SMA units have given 100% uptime for over five years so far with
effectively zero RFI, so I feel it was worth it. Just my $0.02.
Cheers & 73,
Howie - WA4PSC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|