Towertalk
[Top] [All Lists]

Re: [TowerTalk] Datasheet for Rohn TA-55

To: Jim Thomson <jim.thom@telus.net>, towertalk@contesting.com
Subject: Re: [TowerTalk] Datasheet for Rohn TA-55
From: CHARLES MORRISON - N1RR <n1rr@comcast.net>
Reply-to: CHARLES MORRISON - N1RR <n1rr@comcast.net>
Date: Sat, 7 Jan 2017 01:37:23 +0100 (CET)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
There are no adequate documents for TA-55 on the net or from Rohn other than a 
depiction / illustration of the part.
Ive consulted a PE with extensive tower experience and we have made a plan.

This will be used on a new fixed tower.
Thanks for everyone's efforts.
-Charlie N1RR


> On January 6, 2017 at 6:32 PM Jim Thomson <jim.thom@telus.net> wrote:
> 
> 
> Date: Thu, 5 Jan 2017 17:28:44 +0000 (UTC)
> From: GEO Badger <w3ab@yahoo.com>
> To: "towertalk@contesting.com" <towertalk@contesting.com>
> Subject: Re: [TowerTalk] Datasheet for Rohn TA-55
> 
> Charlie,
> I assume you want one with dimensions?
> 
> Here is a page from their 55G catalog, but no dim.
> http://www.w3ab.org/Documents/ROHN/Rohn%20TA55.pdf
> 
> ##  heres the part that I dont get.   The 6 point guy system will reduce on 
> the tower
> where the..cue rack is installed... almost down to nothing.   Is torque even 
> an issue ? 
> 
> ##  these rotating towers  all use rings..and the typ 3 guy wires per 
> ring..are attached  to the
> ring.... not to the tower.   IE:   There is nothing to stop the tower from 
> torquing at all ! 
> The guy wires on the rotating towers just hold up and support the tower, they 
> dont provide
> any torque redux  at all.     Then folks install 188-220 ft tall rotating 
> tower assys... with the
> usual myriad of large HF yagis on them, typ with a 80m yagi  at the very top. 
> 
> ##  meanwhile the rotor is at the very bottom, like on the K0XG setups.   The 
> tower appears
> to me to be one big.... mother of all torque wrenches.  The myriad of yagis 
> are all bolted to
> the same tower face too.  How much to these rotating towers actually twist in 
> high winds ??? 
> 
> ##  If twist is a non issue on a rotating tower, then why even mess with the 
> ...cue-rack..aka 
> rohn TA55  assy at all ??   What am I missing here ? 
> 
> Jim   VE7RF
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>