Towertalk
[Top] [All Lists]

Re: [TowerTalk] Strength of installation raising cable for the LM470?

To: Jim Thomson <jim.thom@telus.net>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Strength of installation raising cable for the LM470?
From: Dan Bookwalter via TowerTalk <towertalk@contesting.com>
Reply-to: Dan Bookwalter <N8DCJ@YAHOO.COM>
Date: Sun, 28 Aug 2016 23:55:31 +0000 (UTC)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Jim VE7RF"##  On the UST towers, the cable attaches to the tower, ALMOST to the 
TOP of
the very bottom"
said that ...
if you are talking about the cable that raises the tower vertically , yes ...
but , the connection point for raising from horiz to vert , hence raising 
fixture ....
that is absolutely not true ...
My UST TX-472 raising fixture cable attaches at about 7'3" up from the bottom 
of the base section...
will supply pics if needed...
Dan N8DCJ

      From: Jim Thomson <jim.thom@telus.net>
 To: towertalk@contesting.com 
 Sent: Sunday, August 28, 2016 12:42 AM
 Subject: [TowerTalk] Strength of installation raising cable for the LM470?
   
Date: Sat, 27 Aug 2016 19:26:47 -0400
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Strength of installation raising cable for the
LM470?

When installing the LM470 using the raising fixture, the retracted tower 
is raised from horizontal to vertical.  The cable attaches to the tower 
roughly half way out presenting one whale of an initial load on the 
cable and winch.
K8RI

##  On the UST towers, the cable attaches to the tower, ALMOST to the TOP of
the very bottom section.  Galvanized .25 inch  winch cable is rated for 5700 bs.
.25 inch SS  cable is rated at one helluva lot less.  .25 inch galvanized 
aircraft cable
is rated at 7000 lbs  bs.  Although galvanized winch cable  looks identical to 
aircraft
cable, the BS ratings are vastly different.  .3125  or  .375 aircraft cable is 
even stronger
of course.  2-4  pulleys will take the stress off of any cable used.

##  UST welds a small rectangular steel plate to one tower leg, with a hole in 
it. Welded
on all 4 x sides.  IMO,  it would be nuts to terminate the cable only  1/2 way  
along the
bottom section.  You might want to re think what they have done,  esp if laying 
the
tower over, with a mast, rotor,  ant on top. 

Jim  VE7RF

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>