He is referring to the PST61, not the D version. (old or new versions?
New uses a DC motor) They look the same and I believe have the same
internal parts, but with a different motor.
For the internal parts of the PST61 (old style) see
http://www.rogerhalstead.com/Gears.htm This has a lot of photos and is a
large page. I'd not recommend it for a dial-up connection. It does cover
almost everything in there.
I believe the new ones are similar.
The body of mine is held onto the mount with 4, (I believe 6mm ) bolts,
not machine screws. HOWEVER they are inadequate for the PST61s full
ratings, let alone the D models ratings. I've never seen them sheared
in a PST61, but rather the threaded holes failed. This is cast Aluminum
which is rather soft. The caps on those bolts are shown in photo 32 at
the end of the page, but I have no photos of the actual bolts. The cover
for the 10T pot is screwed to those.
*NOTE: *When replacing this "10 turn" pot, make sure to determine the
wiper position before, or when removing the failed pot. Measuring the
resistance of a failed pot is not reliable, so with the rotator and one
end of it's travel, or a known position, you can count the turns of the
pot CW, or CCW to the end. Be sure to write it down.
On mine the position of the wiper was near the middle of the 10 turns.
They have addressed the original problem of water in the top seals
causing the output shaft to rust (photo 4) on later models. How well
this works? I don't know, but it looks good. The early models with the
AC motor had the top seals recessed with a raised ring (abt 1/4") around
it. (photo 18) The rusted shaft not only abraded the seals, but formed
an additional path for water entry. Water being more dense than gear
lube will sink to the bottom carrying rust along with it. destroying the
bottom bearing and rusting the bottom shaft. Water will quickly cause
the top bearing to fail.(Photo 2) Note the keyway in the output shaft
(photo 13)
73
Roger (K8RI)
The idea of the Prosistel is a good one, it’s just built to a price, and in
some places it shows.
The PST61 of mine that failed, was due the FOUR tiny metal machine screws that hold the
rotator onto the bottom casting. There’s no interlocking castellation’s or
anything like that, your large antenna relies on those four small screws, and once they fail,
(and they will if you have a large antenna) your rotator will need a repair and more than
likely modification at the same time.
73
Andy
<http://gd0tep.com> http://gd0tep.com
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|