Thread lock compound isn't really permanent. Heat causes thread lock compound
to release.
I use Loctite 262 "High Strength Stud & Bearing Mount" to hold the shift levers
in place on my
racecar's A833 four speed. When it's time to R&R the gearbox, a propane torch
works to
heat it up, and the fasteners can then be removed. From Loctite FAQ:
Q: I cannot get an assembly apart where a threadlocker was used. What solvent
will break the
threadlocker down?
A: No solvent will wick into the joint to break the threadlocker down. This is
either hand tool
removable at room temperature or if not, it requires high temperatures of
450-600°F to separate
parts.
vy 73,
Bryan WA7PRC
NHRA ET6201
Date: Wed, 27 Jul 2016
From: Jeff AC0C
To: Stein-Roar Brobakken RagLB3RE, Jim Thomson
Cc: TowerTalk
Subject: Re: [TowerTalk] Lockwasher Comparison
I would second Jim's advice on locktite red. I would use that only on
something that I really wanted to never come off. In some cases I have had
to use a torch on a nut bound by red. Looking at the stuff you would not
believe it could hold that well but in some cases it definitely does...
73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|