For clarification, I am looking for a tower mounted control box with the
components installed. No limit switches or cables. Thanks.
> On Jul 22, 2016, at 20:40, Roger (K8RI) on TT <K8RI-on-TowerTalk@tm.net>
> wrote:
>
> My LM470 uses a plastic replacement instead of the Hoffman box (PVC?) and
> they don't rust.
>
> 73
>
> Roger (K8RI)
>
>
>> On 7/22/2016 Friday 10:28 PM, Bob K6UJ wrote:
>> Ed,
>>
>> I have an HDX-589. Is the metal enclosure rusted out ?
>> If so, a new Hoffman box wouldn't be too much. You could
>> reinstall the electrical gear in a new box for a lot less than $1000 :-)
>>
>> Bob
>> K6UJ
>>
>>
>>> On 7/22/16 2:04 PM, Ed via TowerTalk wrote:
>>> I have an HDX-589 tower that is need of a replacement control box. In
>>> looking at the original design, compared to the latest design in my
>>> HDX-5106, they're "apples n oranges."
>>>
>>> The 589 is much older and has a complex electrical layout whereas the 5106
>>> box uses three components only (terminal strip, fuse holder and switch). I
>>> called UST and they're asking $1000 for a replacement. Ripoff.
>>>
>>> Long shot here - does anybody have a control box they'd like to part with?
>>> Not holding my breath but worth a try.
>>>
>>> 73,
>>> Ed NI6S
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|