Hi All.
Yesterday I pulled my Explorer 14 out of the barn where it has been
since late 1993 and cleaned off the acquired patina. I'm thinking that
it would be a good idea to at least open and inspect the traps. While I
can figure it out after a few tries I'd rather not ruin the first few in
the learning curve!
I presume the trap end caps are a friction fit. I've also seen from
various pictures on the Web that one end has a tab that connects the
outer cover (capacitor tube) to the element tube. I presume the cover
is removed sliding away from the trap assembly in the direction of the
tab. I am aware of the internal spacers and that there are dimples in
the outer cover that hold the spacers in place. Any tips on removing
the covers other than brute force with a hammer? How about reassembly?
I found where one op in Europe affixed mosquito netting over the trap
drain holes to keep critters out in the future. It seems like an
interesting idea, although I'm not sure it it's needed.
Thanks for any tips and suggestions.
73, Nate, N0NB
--
"The optimist proclaims that we live in the best of all
possible worlds. The pessimist fears this is true."
Ham radio, Linux, bikes, and more: http://www.n0nb.us
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|