Date: Tue, 21 Jun 2016 23:21:59 -0700
From: Jim Brown <jim@audiosystemsgroup.com>
To: towertalk@contesting.com
Subject: Re: [TowerTalk] To get a truly balanced antenna feed
On Tue,6/21/2016 9:31 PM, Roger (K8RI) on TT wrote:
> Didn't you once say "there is no such thing as a balanced antenna"?
Yep, but I was speaking more in terms of perfection -- i.e., that in the
real world, most practical antennas are unbalanced by their
surroundings, even if we attempt to make them a balanced antenna and
feed them with 2-wire line and a so-called balance tuner. It is that
imbalance that causes common mode current. If the imbalance is
relatively small, and if the antenna is resonant and fed with coax, we
can choke it effectively.
73, Jim
## OK, say in the case of a rotary dipole on a freestanding tower, say mounted
part way up a mast, what exactly is unbalancing it ?? I cant see it being
stray C
to the dirt below, since that value is miniscule at best. However, I can see
stray C
between the rotary dipole and what is immediately beneath it, like the boom +
els
of say a yagi.... 5-8 ft below the rotary dipole. And this is all assuming
that the
rotary dipole is mounted in line with the yagi boom below it.
## Ian mentions the current. If that’s the case, why not just measure the
current with a clamp
on ammeter.... at say several random places on the coax feedline ? Then we
have yet another issue
to deal with, and thats what if the coax braid is bonded to the top of the
tower ? If a lousy CM
choke balun is used at the ant feedpoint, and braid also bonded to top of
tower, we can then have
a case where CM current is now flowing down the tower. Then the matter of
how well the base of the
tower is bonded to any ground system... IE: just some rods... or rods +
extensive radial system, etc.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|