You'll be fine with thimble to thimble.
Rich - N5ZC
On 6/2/2016 2:48 PM, StellarCAT wrote:
I had planned on using 1/2” thimbles to couple 5/16” EHS to 5/16” EHS (pieces I
have from a purchase) ... as well as at their ends of course ...
and the same for coupling from the 11200 philly to the 5/16” using the same
1/2” thimbles...
is this a possible issue? Do I need to use insulators instead?
I’d think if there is philly to the top of the tower and the EHS, in 2 ‘coupled’ pieces, down to the
ground – grounded there – there would be no potential for noise being generated through any form of rubbing
– correct?
And wear – the 1/2” thimbles are monsters – I’d think it would take decades for
it to wear if ever... although I suppose it might cause the galvanizing to wear prematurely.
any one have experience with this method?
Gary
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|