Syl,
The C31XR has Force 12's Magnum Easy On mount.
You can leave the boom attached to the mount and rotate the boom down to
where you can
reach the connectors, then rotate it back in place and secure.
Take a look at the Easy On mount in the manual. The plate against the
mast with 2 u bolts on top and bottom
stays intact. Leave these u bolts alone. Remove temporarily all but
one of the bolts securing the outer plate
to the mast plate, loosen the remaining bolt slightly and rotate the boom.
Bob
K6UJ
On 5/27/16 9:46 AM, VE5ZX wrote:
I am feeding an C31XR with separate coaxes on each band. I have faulty
coaxes on 20 & 15 that I need to replace.
Does any know if there way to access the coax connectors on the 20m &
15m baluns that are taped to the boom near each driven element from
the tower so I can change the coaxes?
The 15m driven is about 70 inches from the tower and the 20m about 56
inches .
Tnx - Syl - VE5ZX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|