I think I posted something similar last fall, or Summer, but didn't have
the Dayton rebuilt. I was a bit surprised to find that instead of
bronze bushings, they are simple steel bushings.
I've rebuilt the Dayton winch and it works well, but I don't think it's
quite up to the task of raising and lowering the tower initially and it
takes too much physical effort to turn the crank even with a snatch
block attached to the tower providing a 2:1 reduction.
Whats a good winch to replace it that is considerably easier to turn? I
can purchase commercial, 2 stage worm gear reducers, but in that range
they are expensive.
Either manual, or 120VAC. No battery powered and no huge, heavy winches,
but it needs to lift (or pull) about a ton and remain out in the
weather.. That eliminates about everything I could find.
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|