Eric -
I use BuryFlex and I buy my crimp-on connectors from them. My crimp tool is
from
http://www.hamcq.com/crimping-tool-frame-ratcheting-handle-crimper-clone.html
73, Mike NF4L
> On May 14, 2016, at 11:45 AM, Eric Rosenberg <ericrosenberg.dc@gmail.com>
> wrote:
>
> I suffer from significantly diminished fine motor skills and proprioception
> (the sense of the relative position of neighboring parts of the body and
> strength of effort being employed in movement) of my left hand, and am unable
> to install solder-on connectors.
>
> In light of the fascinating discussion of connectors, I have the following
> question regarding the installation of connectors on RG-8X, RG-213, LMR-240,
> LMR-400 and "Bury-flex" (DavisRF or DX Engineering) cables. I'm not sure
> which ones I'll be using as I re-build my station this summer.
>
> Who are the recommended connector manufacturers of crimp-on connectors for
> these different size cables, and what tools do I need to install them. I've
> noted that ratcheted crimpers range from $15 to $400, and that Times
> Microwave makes their own connectors and tools for their LMR series cables.
>
> While I acknowledge that there is often a direct correlation between cost and
> quality, this is an instance where I need guidance.
>
> Thanks & 73,
> Eric W3DQ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|