Roger,
Good point about nothing will stick to the silicone grease film !
If we are going to wrap the connection with tape, we need to be careful
not to have any of the film on the coax where the wrapping goes.
73,
Bob
K6UJ
On 5/11/16 12:32 PM, Roger (K8RI) on TT wrote:
I've never used that particular product, but I have used Silicone
dielectric greases and find they work well. I used to get the big
tube of DC-4 and 5 compounds for $1.00 ea. That source is no longer
available. Rather I should say, it no longer exists.
HOWEVER there are some things to keep in mind when using these compounds.
Normally use the grease sparingly unless you plan on "flooding" the
connector. Flooding only the top connector "might" not be a bad idea
as it keeps moisture that might get in at the antenna from migrating
past that point, but it's normally not recommended to flood all
connectors. The area between the jacket and dielectric (braid area)
does breathe although it's a tiny volume. Nothing will stick to
connectors, or coax jackets that have even a film of silicone on them.
73,
Roger (K8RI)
On 5/11/2016 Wednesday 12:01 PM, Riki, K7NJ wrote:
I am considering applying Loctite Dielectric Tune-up Grease to the
mating
surfaces of connectors that are difficult to access at the top of a
tower. I
would appreciate comments about this - especially from anyone who has
used
this product for this purpose.
73, Riki, K7NJ
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|