Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rotator Lube

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Rotator Lube
From: Grant Saviers <grants2@pacbell.net>
Date: Wed, 27 Apr 2016 13:28:55 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I agree that SuperLube is terrific for the rotator main ring ball bearings and gears in rotators, plus many other applications.

For supposedly "life time lubricated" sintered bronze sleeve bearings I use a few drops of 5w30, which is probably as good as anything to refresh the oil in the porous bronze, but not much will get in unless submerged in oil and then a vacuum pulled on it to remove the air so the oil will go back into the pores at atmospheric pressure. There are dozens of oils made specifically for sintered bronze, but probably supplied only in 55 gal drums.

For ball bearings that are open, I flush them with a solvent spray, dry (not with compressed air btw), and regrease with a grease without fillers, although SuperLube is an alternative on low speed shafts even with its TFE additive. Cleanliness is everything for bearing life. For high speed shafts I use a ball bearing grease and a synthetic is the best choice e.g. Mobilith SHC 100. There are exotic greases for precision bearings such as ABEC 7 and 9 grades used in machine spindles. $20 per ounce and up. For sealed (rubber seals) or shielded (metal covers) ball bearings I have "resuscitated" a few for a while with a hypodermic insertion of oil (sealed) or a vacuum impregnation (shielded) of oil, as an emergency measure. A decent brake line purging hand vacuum pump works ok if you don't have a motorized vacuum pump.

Greased ball bearings are usually specified to have a grease life of 5 years, but 10 years can happen, and beyond that it's all luck as the oil evaporates leaving behind the oil carrier as hard lumps. Synthetic greases last longer than petroleum oil based greases.

Grant KZ1W

On 4/26/2016 12:56 PM, Wayne Kline wrote:
Hi Wl
I use Super Lube synthetic grease You can get 3 ox tubes at most box HW stores. I like it because it's same viscosity
at ALL temperatures ...
  Wayne W3EA
From:infomet@embarqmail.com
To:towertalk@contesting.com
Date: Tue, 26 Apr 2016 15:36:54 -0400
Subject: [TowerTalk] Rotator Lube

What’s the recommended oil for the motor bearings in Hygain rotators?
WL
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
                                        
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>