Towertalk
[Top] [All Lists]

[TowerTalk] Rotator Choice for Larger Yagi

To: <towertalk@contesting.com>
Subject: [TowerTalk] Rotator Choice for Larger Yagi
From: "Jim Thomson" <jim.thom@telus.net>
Date: Tue, 26 Apr 2016 06:45:17 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Date: Tue, 26 Apr 2016 08:47:56 -0400
From: "john@kk9a.com" <john@kk9a.com>
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Rotator Choice for Larger Yagi


Besides adding a water shield and new clamps to the OR2800, I would
recommend a Green Heron controller.  This controller will work well with
the pulse reed switch with no special cable requirements.

John KK9A

## toss  in the Nord lock washers, and / or  blue loctite..  to the list, and 
you
have a winner.   Im 99%  sure you can buy a OR-2800  without the mating 
M2  control box for it.  Then just buy the OR-2800 +  GH box. 

##  a small traffic cone will also work for a water shield, provided you paint /
cover it 1st...so it doesn’t  look silly being bright red /orange.   That water
shield shown on amazon will do the trick, and fit any diam mast you want. 

##  The K7NV  mast clamp is a thing of beauty, he also uses em on his prop pitch
rotors.   Forget the bolts that compress the flanges,  just pinch them with 
vice grips
and the mast wont budge !  Ok, now add the bolts, tighten em up a bit, then 
remove
the vice grips.  Mast  wont budge...cant slip.  Its a superb design, since it 
has a LOT of surface 
area. Not too many of the teeth on the oem m2 clamp actually touch the mast.  
And they
wont dig into a CM mast anyway.   On K7NVs  clamp, even with a 2 inch mast, it 
provides
> 36 sq inches of surface area.  And > 54 sq inches if a 3 inch mast used.


Jim  VE7RF 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>