I have two of the KK1L switches. They work well. As they say, some assembly
required. But overall a nice design.
As for a band decoder: assuming you have a radio with (DCBA) outputs, Unified
Microsystems has a very nice (and inexpensive) band decoder board.
Ken K6MR
From: Mike Fahmie via TowerTalk<mailto:towertalk@contesting.com>
Sent: Sunday, April 17, 2016 16:59
To: Douglas Ruz / CO8DM<mailto:co8dm@frcuba.co.cu>;
Towertalk<mailto:towertalk@contesting.com>
Subject: Re: [TowerTalk] 6 x 2 unit...
KK1L 2x6 SwitchKK1L Contest Stuff
|
| |
KK1L 2x6 SwitchKK1L Contest Stuff
Amateur Radio, Electronics, Engineering | |
|
From: Douglas Ruz / CO8DM <co8dm@frcuba.co.cu>
To: Towertalk <towertalk@contesting.com>
Sent: Sunday, April 17, 2016 4:13 PM
Subject: [TowerTalk] 6 x 2 unit...
Hi,
I am building a simple as possible SO2R configuration.
I need some advices about a 6 x 2 antenna relay unit.I prefer a kit because
it is cheaper.
I think I need build also a Band decoder.any idea?
Thanks,
Doug, CO8DM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|