Rich,
I don't have a beacon plate handy but I just measured my beacon. It has 5/8"
diameter holes set in a square pattern and the holes are 9 1/4" center to
center (not diagonally).
73,
Jim, W5QM
-----Original Message-----
From: Richard Thorne <rthorne@rthorne.net>
To: Towertalk <towertalk@contesting.com>
Sent: Sun, Apr 17, 2016 12:27 pm
Subject: [TowerTalk] Rohn 55g Beacon Plate Bolt Pattern
I've been searching the net without much luck.
Does anyone happen to know the bolt pattern dimensions of the Rohn 55g
Beacon Plate. The bolt hole dimensions would also be helpful.
Mine's at 140' which makes it tough to measuer.
Thanks
Rich - N5ZC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|