Huh?...Really?
The set up on that would be a bear!..
A plasma cutter and a bit of layout you'd be done before you could set the
mill head....just sayin'.
73
Mike W2GR
----------------
In a message dated 4/8/2016 7:06:29 P.M. Eastern Daylight Time,
K8RI-on-TowerTalk@tm.net writes:
I could rotate the head on the milling machine and bore out the opening
in the tower top plate to take a 3" mast and bearings, but at this
point, it's hardly worth the effort.
73
Roger (K8RI
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|