The manual has a circuit diagram, if that helps...
http://www.radiomanual.info/schemi/ACC_rotator/Yaesu_G-800S_G-800SDX_G-1000S_G-1000SDX_user.pdf
Chuck W5PR
On Thu, Feb 11, 2016 at 4:28 PM, Dave Putman <dave_putman@verizon.net>
wrote:
> As I was installing a replacement lamp on the indicator display of my
> Yaesu G-1000SDX rotator controller, one wire from the indicator motor
> control board pulled loose. This is the first of a pair of grey wires from
> the indicator motor control board (top left corner looking at the board
> from the rear of the controller). It appears to wrap around the rear of
> the motor control board then forward the faceplate - the wire is loose at
> that end. Does anyone have a service manual for this controller?
> Alternatively, if someone who has one of these controllers could examine
> the interior assembly and tell me where the wire connects (or could allow
> me to examine it), please contact me (callsign at ARRL dot net) and I will
> make arrangements.
>
> Dave KE4S
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|